Default is NO. when system power is off, it is always NO.
you can remotely change NO/NC of Sensor and alarm as below.
- Alarm.JPG (76.13KiB)Viewed 351 times
[Nuvis-Alarm] changing NO to NC
Open iVMS and go to "Event management"
Default is NO. when system power is off, it is always NO.
you can remotely change NO/NC of Sensor and alarm as below.
Default is NO. when system power is off, it is always NO.
you can remotely change NO/NC of Sensor and alarm as below.
Return to “NUVIS/EDGE/NEO IP CAMERA”