HDD( Quota ,Group) Redundancy advantage in Nuvis system
Posted: March 31st, 2016, 4:42 pm
Purpose "HDD (Hard Disk Drive) Quota mode is one of the HDD storage modes in CYTE Inc. Nuvis DVRs/NVRs. Whereby
Each camera can be configured with an allocated quota of HDDs to store recorded files and in the other hand CYTE Inc. Nuvis DVRs/NVRs
have a Group mode that Multiple HDDs can be managed in groups. Video from specified channels can be recorded onto a certain HDD group
through HDD settings. CYTE Inc. Nuvis DVRs/NVRs have a built in HDD (Hard Disk Drive) Redundancy (backup hard drive that can be used to
replace the original hard drive in the event that it fails) function.
To enable one HDD has redundant you must follow the instruction as follow.
Enter the Storage Mode interface.
1- Menu > HDD > Advanced 2. Set the Mode to Group, as shown in Figure
2-Click the Apply button and the following Attention box will pop up
3-Click the Yes button to reboot the device to activate the changes
4- After the DVR/NVR reboot go to Menu > HDD > General
5-Select HDD from the list and click the icon to enter the Local HDD Settings interface, as shown
Technically at this point the 2nd HDD is a redundant !
Each camera can be configured with an allocated quota of HDDs to store recorded files and in the other hand CYTE Inc. Nuvis DVRs/NVRs
have a Group mode that Multiple HDDs can be managed in groups. Video from specified channels can be recorded onto a certain HDD group
through HDD settings. CYTE Inc. Nuvis DVRs/NVRs have a built in HDD (Hard Disk Drive) Redundancy (backup hard drive that can be used to
replace the original hard drive in the event that it fails) function.
To enable one HDD has redundant you must follow the instruction as follow.
Enter the Storage Mode interface.
1- Menu > HDD > Advanced 2. Set the Mode to Group, as shown in Figure
2-Click the Apply button and the following Attention box will pop up
3-Click the Yes button to reboot the device to activate the changes
- hdd red.jpg (180.08KiB)Viewed 328 times
4- After the DVR/NVR reboot go to Menu > HDD > General
5-Select HDD from the list and click the icon to enter the Local HDD Settings interface, as shown
- hdd3red.jpg (137.7KiB)Viewed 328 times
Technically at this point the 2nd HDD is a redundant !
- redundant disk.png (40.31KiB)Viewed 327 times