[PTZ/HOME POSITION FEATURE]
Posted: October 1st, 2015, 6:10 pm
*Related Products : SP10AC, SP100, SP130, SP200, SP230
They don't have home position feature but you can enjoy same feature by 'Recover' & " Scan'
1. Move camera to positon where you like to set as home.
2. go to camera menu (Hit preset 95)
3. Go to Pattern/Data Fill/
4. Hit focus - (=focus far) then data fill will flash.
5. Hit focus - one more time then data fill will stop flashing.
6. Go to 'Save' and Hit right arrow to save.
7. Go to 'Exit' and hit right arrow.
8. Go to 'Dome Set'/ 'Recover' and set it 15 Sec~90 Sec
9. Get out of the OSD menu.
8. Start Pattern( Preset 81)
<Warning>
Do not use Tour & Recover setup to have 'home position' feature.
It will be blurry & refoucs every 5~10 sec.
If, camera is spinning 360 degree, change direction from CW to CCW.
They don't have home position feature but you can enjoy same feature by 'Recover' & " Scan'
1. Move camera to positon where you like to set as home.
2. go to camera menu (Hit preset 95)
3. Go to Pattern/Data Fill/
4. Hit focus - (=focus far) then data fill will flash.
5. Hit focus - one more time then data fill will stop flashing.
6. Go to 'Save' and Hit right arrow to save.
7. Go to 'Exit' and hit right arrow.
8. Go to 'Dome Set'/ 'Recover' and set it 15 Sec~90 Sec
9. Get out of the OSD menu.
8. Start Pattern( Preset 81)
<Warning>
Do not use Tour & Recover setup to have 'home position' feature.
It will be blurry & refoucs every 5~10 sec.
If, camera is spinning 360 degree, change direction from CW to CCW.