[SENES5100WIR] RS485 CONTROL SETUP
Posted: October 1st, 2015, 5:57 pm
Pelco D Protocol
Baud Rate : 2400
** Address Setting**
Dip switch on the camera ( default is 1)
** Commands**
IRIS OPEN : Enter
Zoom Tele : Up
Zoom Wide : Down
Focus Far : Left
Focus Near : Right
P.S > it works with Apollo/Titan/Atom DVRs. It does not work with TX-SP for some reason.
Baud Rate : 2400
** Address Setting**
Dip switch on the camera ( default is 1)
** Commands**
IRIS OPEN : Enter
Zoom Tele : Up
Zoom Wide : Down
Focus Far : Left
Focus Near : Right
P.S > it works with Apollo/Titan/Atom DVRs. It does not work with TX-SP for some reason.